Toshiba B-492L - Manual (Page 51)

APPENDIX 4 SYSTEM MODE EO1-33032
A4.1 Operation Panel
A4- 1
APPENDIX 4 SYSTEM MODE
A4.1 Operation Panel
Appendix 4 describes usage of the keys on the Operation Panel in System
Mode.
For end users, System Mode should be used for the following five
purposes:
•
To reset the printer. (Reset mode)
•
To check and print the system status, the Maintenance Counter, and
to check the Print Head Elements.
•
To make fine adjustment to the media handling.
•
To perform a test print for checking print quality.
•
To print the raw data being received by the printer (Dump mode).
The figure below shows the Operation Panel and key functions.
The LCD Message Display shows messages to indicate the printer’s
current status. Up to 16 characters can be displayed on this line.
There are three LEDs on the Operation Panel.
LED Illuminates when…
POWER The printer is turned on.
ON LINE The printer is ready to print.
ERROR Any error occurs on the printer.
In System Mode, the [FEED], [RESTART] and [PAUSE] keys
function as described below.
FEED
Used to navigate the parameter mode or to fine adjust
the parameters in the negative direction (- Down).
RESTART
Used to release the printer from Pause condition, to
navigate the parameter mode, or to fine adjust the
parameters in the positive direction (+ Up).
By pressing and holding the
[RESTART] key in Pause
condition for more than 3 sec., the printer enters the
system mode.
PAUSE
Used to stop printing operation temporarily, to select
the parameter mode, or used as an enter key.
By pressing and holding the
[PAUSE] key in Pause
condition for more than 3 sec., the printer enters the
threshold setting mode.
IMPORTANT!
If System Mode is needed for
any other purposes, please
contact a TOSHIBA TEC
authorized service
representative before
performing any operation in
System Mode.
NOTE:
Use the [RESTART] key to
resume printing after a pause
condition, or after clearing an
error.
FEED RESTART PAUSE
POWER ON LINE ERROR
LCD Message Display
ON LINE LED (Green)
ERROR LED (Red)
[PAUSE] key
POWER LED
(Green)
[FEED] key
[RESTART] key