Toshiba HDD-J35 - Manual (Page 18)

18
INSTALLING THE RECORDER
Follow steps A to C below. Your recorder will be ready to display digital programs on your TV.
STEP A: CONNECTIONS
DO NOT PLUG THE RECORDER INTO THE MAINS YET.
Before you use this recorder, it is necessary to connect it to your TV.
1
CONNECTING TO TV
1-1. Connection to Antenna
Disconnect the antenna cable from your TV and connect it to the “ANT. 1 IN” terminal on the back of the
recorder.
1-2. RF Loop-through Connection
To achieve RF loop-through for the in-built twin RF tuners, connect the RF Coaxial Connectors (supplied) to the
“RF 1 OUT” and “ANT. 2 IN” terminals as shown in the diagram below.
1-3. “RF OUT” Connection to TV or VCR
The “RF 2 OUT” provides you a RF loop-through function to receive analogue TV programs as well as digital
programs (for Integrated Digital TVs only). Use an RF coaxial cable (not supplied) to connect the HDD-J35 “RF 2
OUT” terminal to TV’s or VCR’s antenna input.
Before connecting or disconnecting the antenna cable, unplug the recorder, VCR, TV and
antenna booster, if any.
HDD-J35
RF coaxial cable
(not supplied) To TV antenna input
Antenna cable
(not supplied)
AC IN ~
ANT. 1 IN
RF 1 OUT
ANT. 2 IN
RF 2 OUT
RF Coaxial
Connector