Taiwan Electrical & Electronic Manufacturers N930R - Manual (Page 89)

System Upgrade
This section provides some steps in doing system upgrade for your notebook computer. The
upgrade procedures include the following:
7.1 Memory Upgrade
Your notebook computer offers 200-pin SODIMM (Small Outline Dual Inline Memory
Module) at least 256MB DDR2-SDRAM. The memory compartment is located inside your
computer. The table below lists the possible combinations of different memory module and
memory size.
• Please contact dealer for changing or adding DDR2-SDRAM module. It is not avai
lable for users to change it by themselves.
Based Memory Installing Memory Total
256 MB 0 MB 256 MB
256 MB 256 MB 512 MB
256 MB 512 MB 768 MB
256 MB 1024 MB 1280 MB
512 MB 0 MB 512 MB
512 MB 256 MB 768 MB
512 MB 512 MB 1024 MB
512 MB 1024MB 1536 MB
1024MB 0 MB 1024 MB
1024MB 256 MB 1280 MB
1024MB 512 MB 1536 MB
1024MB 1024MB 2048 MB
INSTALLING MEMORY MODULE
Your computer comes with standard 256 MB, 512MB or 1024MB of synchronous DDR2
SDRAM. You can increase system memory to a maximum of 2048 MB in the system, by
installing two small outline double inline memory modules (SO-DIMMs) with installed base
memory in the system.
The 256MB, 512MB and 1024MB memory modules are available:
To install the memory module:
1. Make sure the system is powered off, the battery also is removed and that no peripheral
devices are attached.
2. Turn the computer upside-down and locate the screw that secures the DIMM door at the
underside of the notebook.
Eng
lish
MANUAL INGLES OK 20/7/06 11:40 Página 88