Toshiba TEC TRST-56 SERIES - Manual (Page 10)

2. SPECIFICATIONS EO1-13016
2.2 Receipt Roll
2- 2
2.2 Receipt Roll
Paper type Thermal paper rolled with the print side facing outside
Width (W) 80 +0/-1 mm
Outer diameter (D) 80 +0.5/-1 mm
Paper thickness (T) 0.075
±
0.005 mm
Weight 69
±
3g/m
2
Outer core diameter 18 mm
Inner core diameter 12 mm
Recommended thermal paper Only paper rolled onto a core is acceptable, however, the paper end
should not be pasted to the core.
Normal paper:
PD150R OHJI PAPER (Japan)
Long storable paper: PD152R OHJI PAPER (Japan)
•
Do not store the paper for longer than the manufacturer’s recommended shelf life.
•
Store the paper in a cool, dry place. Avoid areas where they would be exposed to direct sunlight,
high temperature, high humidity, dust or gas.
•
A contact of chemical or oil may discolour or erase the printed record.
•
Rubbing the paper hard with nail or hard object may discolour the paper.
•
The paper end should not be pasted to the core.
For further information please contact your authorised TOSHIBA TEC representative or authorised
paper manufacturer.
CAUTION!
Use only paper which meets specified requirements. Use of non-specified paper may shorten the
head life of the printer, resulting in problems with print quality, cause a paper feed failure or shorten
the cutter life. All paper should be handled with care to avoid any damage to the paper. Read the
following guideline carefully.
Width (W)
Inner core
diameter (ID) Outer core
diameter (OD)
Outer
diameter (D)
Paper
thickness (T)