Toshiba TEC TRST-56 SERIES - Manual (Page 12)

3. APPEARANCE EO1-13016
3.3 Connectors
3- 2
3.3 Connectors
c
[Interface connector] (Serial interface model: D-SUB 25-pin Socket Connector,
Parallel interface model: IEEE 1284-B receptacle)
An interface cable which connects the printer to a POS terminal is connected to this connector.
A Centronics interface cable (Parallel I/F model) or an RS-232C interface cable (Serial I/F model)
is connected.
d
[Drawer interface connector] (6-pin modular connector)
A drawer cable which connects the printer to a drawer is connected to this connector. To this
connector, a TOSHIBA TEC drawer can be connected. Do not connect anything other than the
connectable drawer.
NOTE: For the connectable drawers, refer to your nearest authorised TOSHIBA TEC
representative.
e
[DC24V] (Socket connector)
The built-in AC adapter supplies +24V power to the printer through this connector. Do not connect
anything other than the built-in AC adapter.
f
[AC Inlet]
The AC power cord is connected to this inlet.
g
[Ground terminal]
The drawer interface cable’s ground wire is secured to this terminal.
CAUTION!
1. The drawer interface connector is exclusively for connecting the drawer. Do not connect a
phone line or any other cables than the drawer cable to this connector. Doing so may cause a
failure of the phone line and this printer.
2. To the DC24V connector (socket connector), do not connect anything other than the built-in
AC adapter.
3. The built-in AC adapter is exclusively for this printer. Do not use it for any other machines.
d e
f
g
c