Thermador PRO GRAND PRD48 - Manual (Page 13)

English 11
To Reinstall the Oven Door:
1. Position the door at a sharp angle (see Figure 7) and
insert the hinges centered evenly into the hinge slots.
The hinges will securely hook into the slots when
properly installed. Do not force, bend, or twist the door.
•
Tip: Rest the door on your foot while using your leg
for stability.
2. Open the door fully and use a screwdriver to push the
hinge clips all the way into the hinge slots (toward the
oven) until they meet the hinge. Be careful not to
scratch the range during this process.
To Check Door Fit and Operation:
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. Do not force
the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. If the door does not operate correctly, verify that the
hinges are properly seated into the hinge slots, and
that the hinge clips are fully engaged into the slots.
3. For large and small ovens, if door or handle appears
slightly tilted, you may adjust the hinge receiver by
rotating the large Torx-head screw located directly
above the hinge receiver with a T-20 Torx driver.
Rotate each screw respective to its side and direction
the door needs to be adjusted (Photo D).
•
The warming drawer and steam oven doors are not
adjustable.
Figure 7: Approximate Door Angle for Removal
23°
Turn this
screw to
adjust door
alignment
Photo D