Technicolor - Thomson ST585 V6 - Manual (Page 105)

E-DOC-CTC-20061027-0004 v1.0
Connection Commands
81
6 Connection Commands
Introduction
This chapter describes the commands of the connection command group.
Contents
This chapter covers the following commands:
connection appconfig Configure the available CONN/NAT application helpers. 82
connection appinfo Display CONN/NAT application specific info. 84
connection applist List the available CONN/NAT application helpers. 85
connection bind Create a new CONN/NAT application helper/port binding. 86
connection bindlist List the current CONN/NAT application helper/port bindings. 87
connection clean Clean the connection database by forcing timeouts. 88
connection clear Kill all the connections. 89
connection config Configure the connection handling. 90
connection debug The connection debug commands 91
connection describe Describe the streams of a connection. 92
connection flush Flush the current connection configuration. 93
connection info Show all the registered modules with some info. 94
connection list Display the currently known connections. 95
connection refresh Invalidate all the cached decisions. 96
connection stats Display the connection and stream statistics. 97
connection timerclear Clear the connection timeout to default. 98
connection timerconfig Configure the connection timeout handling. 99
connection unbind Delete an existing CONN/NAT application helper/port binding. 100