Teac E24E - Manual (Page 38)

For Windows 98SE/Me/2000
28 TEAC PortaCD-RW User’s Manual
Installing the PortaCD-RW Driver Using the Windows Wizard
This section explains how to install the PCMCIA driver using the Windows Add
New Hardware Wizard.
For Windows 98SE/Me/2000
The installation procedure for the PCMCIA Card Driver varies depending on the
version of Windows 98SE/Me/2000 installed in your computer.
To install the driver on a Windows 98SE/Me/2000 system, follow these steps:
1. Insert the PCMCIA card into the PCMCIA card slot in your laptop
computer.
The other end of the card/cable should already be connected to the interface
connector on the PortaCD-RW. (If not, see “Chapter 3. Connecting the
PCMCIA PortaCD-RW to a Windows System” on page 23 for more
information.)
The system displays the initial Add New Hardware Wizard panel (Figure 30).
Figure 30. Add New Hardware Wizard
2. Click the Next button to search for the driver.
The system displays the following Add New Hardware Wizard panel
(Figure 31 on page 29), asking what you would like Windows to do:
Note: The system configuration and your dialog responses determine which panels
the Wizard will display. Do not be concerned if your installation process varies
slightly from the one described below—just follow the dialog instructions.
PortaCDRW.book Page 28 Wednesday, April 4, 2001 10:49 PM