Thermador SB2B - Manual (Page 11)

6. The cooktop is supplied with a pressure regulator
that is packed with the unit. The regulator is set
for natural gas. For use with propane, it must be
converted. The regulator will be located on the
left rear bottom of the unit. Using a flat blade
screwdriver, remove the cap on the top of the
regulator and turn the cap over so that the letters
LP are exposed. Make sure the spring in the
regulator remains in position. Reattach the cap to
the regulator. See Figure 9, right.
SECTION 5: UNPACKING AND PLACING THE UNIT
5. The bypass jet must be turned clockwise with a
small flat-bladed screwdriver until fully seated to set
proper low flow rate. See Figures 7 and 8, above.
FIGURE 9
FIGURE 7 FIGURE 8
Steps continue on next page
9