Thermador SB2B - Manual (Page 16)

SECTION 8: CARE AND CLEANING
The quality of this material resists most stains and pitting, providing
the surface is kept clean and protected with a stainless steel polish.
Nonabrasive Cleaners: detergent and water, Fantastik
® , 409 ® , vinegar.
Mild abrasive Cleaners: liquid Kleen King ®
Stainless Steel Polish: Stainless Steel Magic ®
• When removing the grates, care should be taken in lifting them. Be
sure to place the grate on a protected surface.
NOTE: Grates will develop bilsters and chips in the porcelain with use due
to the extreme operating temperatures
Hot sudsy water and mild abrasive cleaners: Bon-ami®, Soft Scrub®.
For stubborn stains: a soap fllled steel wool pad.
• Wash, rinse and dry. The occasional use of mild abrasive cleaners or
steel wool soap-filled pad is okay. Abrasive cleaners, used vlgorously
or too often, can eventually harm the enamel. Apply with a damp sponge,
rinse thoroughly and dry.
Make certain that burners are turned OFF before cleaning.
Ports – Clear ports of any soil with a Wire, straightened paper clip
or needle. Wash in hot sudsy water. Rinse and dry.
Caps – Wash in hot sudsy water. Rinse and dry. For hard-to-remove soil,
use powdered cleaners such as Ajax®, Bon-ami®, Comet®.
Hot sudsy water.
• Pull knobs straight forward. Wash, do not soak. Rinse, dry and replace.
Make certain the knobs are reinstalled In the proper location. Do not
force knobs onto wrong control.
Exterior Finish/Cover
Stainless Steel
Grates
Porcelain Enamel
on Cast Iron
Burner Ports and Caps
Aluminum / Porcelain
Control Knobs, Bezels
Plastic / Chrome
PART and MATERIAL SUGGESTED CARE
14