Winding the under thread – TOYOTA EPS9000 User Manual
Page 24
PREP
ARAT
IO
N
PREP
ARAT
IO
N
24
WINDING THE UNDER THREAD
1.
Set a bobbin (2) on the under thread winding shaft (1).
2.
Place the spool (3) on the spool stand on the cover, pass the thread end through the thread tension regulator
guide (4) and wind the thread round the bobbin (2).
3.
Press the thread winder lever (5) to the right so that it touches the inner face of the bobbin (2).
4.
Thread is wound on the bobbin as the machine operates and the lever automatically returns back (turning to the
left) when a certain amount of thread is wound on the bobbin to stop winding of the under thread.
Under thread may be used up during embroidery. In this case, set the under thread in the same manner as
explained above.
Bobbin (2)
Cover
Thread tension
regulator guide (4)
Spool (3)
Thread winder lever (5)
Spool stand
Under thread winding shaft (1)