Toro TMC-424E - Manual (Page 6)

• Multiple Program Operation
1. Turn Function Dial to
Manual Programs .
2. Set the Program Switch to select pro-
gram A, B, C, or D.
3. Press the button to start the program
watering cycle. The program identifier
will begin flashing and Water On icon
will be displayed.
4. To select additional programs, repeat
steps 2 and 3.
5. Turn the Function Dial to RUN .
• The operating program identifier, station
number(s), remaining station run time
and icon will begin alternating with
the current time of day.
• The programs will operate in the order
selected, either sequentially or
concurrently as determined by the
Stack/Overlap option selection.
• Automatic mode will resume when
the manual operation is finished.
• To turn off an active station and start
the next station in sequence, position
Program Switch (if needed) to select
the program, then press the button.
• To end manual operation at any time,
turn the Function Dial to OFF .
When the display to stops flashing, turn
the Function Dial to RUN .
1. Set the Program Switch to select
program A, B, C, or D.
2. Turn Function Dial to Station Times .
3. Press the or button to select
the station number. The corresponding
station output terminal will be shown
on the display as a solid circle.
Set Station Run Time
6