DVico TVIX PVR R-2230 - Manual (Page 56)

Ultimate PVR with HD Digital Jukebox
56
7.3.7 Wireless Network
[ Connect USB wireless module ]
Connect the USB module into enclosed cradle after connecting the AP Router to a PC.
You should not connect the USB module to TViX without the cradle. If you connect it by force, the TViX
can be damaged. if you have TViX PVR 2200 series, you must use enclosed USB host cable.
Please refer to the TViX homepage(www.TViX.co.kr) for a list of compatible wireless devices.
[ Configure Wireless Network ]
After booting, press SETUP-NETWORK- “Wi-Fi IP setting” and select DHCP or static IP.
After selecting DHCP, press “Search Wi-Fi Network” for searching your AP or AP router.
After the interval of searching, you can see following popup menu. Select the AP you want to get connect
with
A red colored icon means the AP uses WEP (Wired Equivalent
Privacy) and a blue colored icon means a non-WEP AP.
Currently supported WEP (Wired Equivalent Privacy) settings are the
OPEN System and
WPA(Wi-Fi Protected Access) .
WEP key input : WEP 64-Bit/ WEP 128 key and ASCII and HEXA
key.
Old firmware is not supporting the HEXA key.
WPA key input : ASCII only.
RADIUS (Remote Authentication Dial-In User Services) servers are
not supported.
You have to configure the WEP setting of the AP using the ※
AP’s instruction in advance.
Insert the network key using the remote’s numeric keys. As you
press the MENU button, the input mode for the remote will be cycle
from lowercase alphabet to uppercase alphabet to numeric input
mode.
To delete a character, press the Capture/Delete button. ☞
If you insert exact network key, you could see well-formed TViX
Wi-Fi Network Info like following. network key is Hexa or ASCII.
If the network key is wrong or the AP doesn’t work with DHCP
setting, you would see some missing fields in TViX Wi-Fi Network
Info POP UP. Those fields which you might always see are SSID and
MAC
If you still have the problem after filling up correct key, please
recheck your setting of AP or reconnect the USB port.
Network disk setting : This setting is same as the wired network
setting. To configure the network disk, refer to TViX FAQ or NetShare manual
※ Caution ※
If you connect to a secured AP, the network performance will be 10% lower than an unsecured
AP.
In wireless connectivity connecting the Wireless USB to TVIX Device. The TVIX needs to be
powered off initially and then Powered ON .Then on the Network setting Menu WIFI IP setting will be
enabled
For better Wi-Fi signals adjust the position of AP and USB module
If you play high definition files over Wi-Fi, you will see stuttering. Also, depending on the
environment, you may experience stuttering when you play DVD files.
If you use a USB Wi-Fi adapter with another USB device, it may not work properly.
* If you want to change AP, you have to search the wireless network as in Step 2.