Toshiba MW30G71 - Manual (Page 55)

55
Other functions (VCR)
Duplicating a video tape
If you connect the unit to another VCR or Camcorder, you can
duplicate a previously recorded tape. Make all connections before
turning on the power.
Duplicating a video tape
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer’s
instructions. A typical camcorder dubbing hookup is
shown above.
Connection with Camcorder
• Select “VIDEO2” on step 2.
Press SPEED to select the desired tape speed
SP or SLP.
It is recommended that you set the
Speed to the SP mode on the
recording VCR for best results.
1
Press INPUT repeatedly to select AUDIO/VIDEO
input position. 2
Press PLAY on the playback VCR or camcorder.
3 Press REC.
4
Press STOP after duplicating a video tape. 5
VIDEO1: on the rear panel
VIDEO2: on the front panel
Preparation:
• Press TV/VCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Load a previously recorded tape into the playback
VCR or Camcorder.
Connection with second video recorder
• Select “VIDEO1” on step 2.
TV/VCR
INPUT
STOP
REC
SPEED
Other functions (VCR)
TV/VCR VIDEO1
To AUDIO (R) IN
To VIDEO IN
To AUDIO (L) IN
Audio/Video cable
(not supplied)
Playback VCR
Rear of the unit (Illustration of MW30G71)
To AUDIO (L) OUT
To VIDEO OUT
To AUDIO (R) OUT
To AUDIO (R) IN
To AUDIO (L) IN
To VIDEO IN
Front of the unit (Illustration of MW30G71)
Playback Camcorder
Audio/Video cable (not supplied)
To AV Jack
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs and other materials,
is prohibited under the Copyright Laws of the United States
and other countries, and may subject you to civil and/or crimi-
nal liability.
5U30101B [E]p55-56 4/1/05, 3:27 PM 55