Tasco 1575 User Manual
Page 107
40 RPH LONG SHAFT SYNCHRON AC MOTOR
Synchron #366661-6, 110VAC, 60Hz
motor which is self-starting and made for
long life operation. 40 revolutions per
hour. Has an aluminum rotor cover and a
precision rotor shaft with double bear-
ings for quiet operation. Gearcase is sealed to permit
mounting in any position. CW rotation. Shaft, 3/16" dia. x
3-1/8" long. Motor is 2" diameter by 1-3/8" deep. Two
mounting holes and 7" wire leads.
M2106P $8.50
HIGH TOLERANCE 5VDC BRUSHLESS BALL BEARING
MOTORIZED SPINDLE
This motorized spindle, designed for Digital Equipment
Corporation, is designed for a rotational speed of 5400
RPM and consists of an eight-pole permanent magnet
rotor with integral disk mounting hub, a three-phase
wye wound stator winding, and a three terminal inter-
connect. The connection to the driver electronics is
through a flexible printed circuit assembly. This spin-
dle was designed to be utilized in a 2.5 inch disk storage device and requires
a special driver to operate. Spec sheet included and we have got a large
quantity of these if you can incorporate them into a product. Unused.
M2160 $5.00
SMALL DC MOTORIZED GEAR ASSEMBLY
An interesting assembly for the electronics "do-it-
yourselfer". The assembly black plastic casing meas-
ures 4 15/16" long x 1 5/16" wide, and includes a 1" long
mounted motor with screw shaft, connected to dual
plastic gears. The final gear has an 1/8" diameter posi-
tioning hole near the edge that aligns with a notch in
the case side panel. Power to the motor is supplied
through dual wires connected to what appear to be DC battery clips. A
dual-wired 1/8" plug is attached to the casing and motor. The assembly has
four base attachment tabs. Runs on 1.5 VDC (slow) to 9 VDC (fast) range.
Output gear rotates between 30 and 50 RPM.
M2185 $3.00
Motors - Page 105
Surplus Shed – www.SurplusShed.com