Measure insert, Apc to smf convert, Select the function – Technics sx-PR604/M User Manual

Page 82: Part iv sequencer

Advertising
background image

MEASURE INSERT

Insert specified measures at a specified point.

• The length of the performance accordingly increases by

the number of inserted measures.

1.

Specify the measures you wish to copy from
the source track.

• On the FROM side, specify the settings with the corre-

sponding buttons.

TRACK: Specify the track number you wish to copy the

measures from.

• This function does not work for the CHORD or

RHYTHM track in which the repeat function has been
stored.

• If ALL is selected, the measures are inserted in all

tracks at the same time.

FIRST MEAS: Specify the first measure to copy.
LAST MEAS: Specify the last measure to copy.

2.

Specify where you wish to insert the selected
measures.

• On the TO side, specify the settings with the correspond-

ing buttons.
TRACK: Specify the track number.

• Measures from the CHORD, RHYTHM or CONTROL

track can only be inserted in the same track.

START MEAS: Specify the start point to insert the selected

measures.

REPEAT: Specify the number of times the selected meas-

ures are to be repeated.

3.

Press the OK button.

• The confirmation display appears. Press the YES button

to execute the function, or press the NO button to cancel
the function.

• Note that if the END command is included in the source

data, it is also inserted. Any data following the END
command is not inserted.

APC TO SMF CONVERT

When a sequence is recorded using AUTO PLAY CHORD,
the SEQUENCER data just contains a chord sequence on
one track. APC TO SMF CONVERT creates a sequencer file
in which the APC/CHORD/RHYTHM/CONTROL parts and
PIANO PERFORMANCE PADS (PR804) phrases are each
recorded on a separate track, allowing you to save the
sequence in standard MIDI File format for playback on other
instruments.

1.

Use the TR

▲ and ▼ buttons to select the

track you wish to convert.

• In the PART column, the part name currently assigned is

shown.

• In the DATA column, a check mark (√) indicates a track

in which data is stored.

• Tracks in which RHYTHM, CONTROL, APC and CHORD

parts are stored cannot be selected (– – – is shown).

2.

Use the APC/PAD

∧

and

∨

buttons to select

the parts you wish to convert.

• Parts that are set to OFF will not be converted.

3.

Press the CONVERT button.

• Note that after the conversion, the automatic accompa-

niment part data is cleared; if necessary, save this data
beforehand.

• A confirmation display appears.

4.

Press EXECUTE to continue with the conver-
sion, or press the CANCEL button is you wish
to discontinue.

• After the EXECUTE button is pressed, the conversion

begins. Conversion takes the same length of time as
playback.

• If you wish to discontinue the conversion process midway,

press the ABORT button.

Changing the note position etc. of the re-
corded data

You can change the note pitch and position etc. of recorded data.

Select the function

1.

On the SEQ MENU display, use the SONG

∧

and

∨

buttons to select the number of the

song. Then select RANGE EDIT.

• The display looks similar to the following.

2.

On the RANGE EDIT display, select a function.

3.

Perform the editing procedures. (See below.)

• During the editing procedure, if the indicator for the

TEMPO/PROGRAM is lit, you can use the TEMPO/PRO-
GRAM
for the editing function.

Se

q

u

e

n

c

e

r

Part IV

Sequencer

82

QQTG0665

Advertising
This manual is related to the following products: