Toshiba 2032SP User Manual
Page 36
Answering Calls
1.
Make sure the phone function is on.
2.
When a call comes in, answer the call by tapping
. Depending on
your settings, your PCS Device notifies you of incoming calls in the
following ways:
ᮣ
The device rings or vibrates.
ᮣ
The LED flashes.
ᮣ
The screen displays an incoming call message.
ᮣ
If available, the phone number of the caller is displayed.
ᮣ
If the phone number is in the Pocket Outlook
®
Contacts list, the list
entry’s name is displayed.
Tapping
or the Volume button can mute the ringer tone.
Note:
If the phone function is off, incoming calls go to voicemail.
3.
To disconnect the call, tap
.
Note:
When
is tapped during an incoming call, it is rejected and
the missed call icon
appears.
About Any-key Answer:
ᮣ
When activated, Any-key Answer enables calls to be answered by
tapping any button, other than the
,
or Volume buttons.
This also includes the four program buttons on the front of the device.
ᮣ
To set, in the
VOICE
tab screen, tap
Tools
,
Options
, and then
Voice
at
the bottom of the screen. For more information, see page 70.
About Caller ID:
If a call is received from a number stored in the Pocket Outlook
®
Contacts
list, the name and number will be displayed. “Unknown” will be displayed
if the caller is not on the Contacts list.
BACK
BACK
Section 2: Understanding Your Device
2B: Phone Function - The Basics
63
Section 2: Understanding Your Device
62
2B: Phone Function - The Basics
Volume Control
Adjust the ringer volume by using the Speaker Icon
on the navigation
bar. And adjust the call volume by using the Volume buttons.
Speaker Icon button:
The ringer type changes each time you tap the Speaker Icon button
.
The setting options in standby mode are “Ringer Only,” “Ring and Vibrate,”
“Vibrate Only,” and “Ring and Vibrate Off”.
During a call, the setting switches between “Sound on” and “Mute”.
Volume buttons:
When you tap the Volume buttons
, a volume bar appears on the
screen to indicate the call volume level (6 levels excluding Mute).
The call volume can be adjusted by tapping
Tools
, then
Options
, then
Sounds
at the bottom of the screen.
Speaker Icon button
Speaker Icon
Volume buttons
SPRINT2B.QXD 02.8.6 6:43 PM Page 62