Tripp Lite PDUMH15ATNET - Manual (Page 3)

3
Mounting the PDU
The PDU supports four primary mounting
configurations: 1U Rack, 0U Rack, Wall and
Under-Counter.
Note: Regardless of configuration, the user must determine the
fitness of hardware and procedures before mounting. The PDU
and included hardware are designed for common rack and rack
enclosure types and may not be appropriate for all
applications. Exact mounting configurations may vary.
1-1 1U Rack Mounting: Attach the PDU to the
rack by inserting four user-supplied screws
through the PDU mounting brackets
and into
the mounting holes of the rack rail as shown.
1-2 0U Rack Mounting: Remove the screws
attaching the mounting brackets to the PDU,
change the orientation of the brackets as shown
and reattach the brackets. Use only the screws
supplied by the manufacturer or their exact
equivalent (#6-32, 1/4" flat head). Attach the
PDU vertically by inserting two or more user-
supplied screws
through the PDU mounting
brackets and into mounting points in the rack
or rack enclosure.
1-3 Wall or 1-4 Under-Counter Mounting:
Remove the screws attaching the mounting
brackets to the PDU, change the orientation of
the brackets as shown and reattach the brackets.
Use only the screws supplied by the
manufacturer or their exact equivalent (#6-32,
1/4" flat head). Attach the PDU to a stable
mounting surface by inserting two or more
user-supplied screws
through the PDU
mounting brackets and into secure points on
the mounting surface.
B
A
C
B
A
C
B
A
1-1
1-2
1-3
1-4
A
B
B
A B C
B
C
A
Installation
A
C
2 PDUMH20ATNET PDUMH15ATNET
Connecting the PDU
The PDU includes two AC power inputs:
Primary and Secondary. The Primary input cord
is permanently attached to the rear of the PDU.
The Secondary input cord is detachable and
connects to the IEC power inlet
at the rear of
the PDU (PDUMH15ATNET - IEC-320-C14
inlet; PDUMH20ATNET - IEC-320-C20 inlet).
2
200706234 93-2701 PDUMH15-20ATNET OM.qxd 7/11/2007 4:51 PM Page 3