Thermador MT27 - Manual (Page 4)

Page 4
Step 4: Installing the Trim Kit
A. Position the 2 vertical trim brackets using the template as shown on Figure 3.
B. Position base pan on cabinet shelf with respect to the center line as shown on Figure
4. The front end of pan should align flush with the front edge of the shelf. Fasten base
pan to shelf with 2 screws #8 x 1/4.
Template is used to locate the positions of the left and
right trim brackets with respect to the cut out. The
trims are secured with (3) screws each and the tem-
plate is discarded after.
Mark the center line of the cut out using the template.
Notch to mark
the center line of
the cutout.
Screws #8 x 1 /
4
➝
Trim Brackets
.
Centerline
cutout
➝
CENTERLINE MARK
Screws #8 x 1 / 4
Figure 3.
Figure 4.
➝
Template