Thermador MT27 - Manual (Page 5)

Page 5
Step 5: Installing The Microwave Oven (Figure 5)
1. Remove and retain outer case screw at rear
of the oven (left side)
2. Position upper exhaust duct on top (Hinge
Side) of oven. Fasten with outer case screw
3. Position side duct on left side of oven and
fasten it together with upper exhaust duct
by using 2 screws #8x1/4.
Figure 5.
Microwave
Oven
Outer
case
screw
Top
intake
duct
Screw
#8x1/4
Rear
intake
duct
.
Outer case
screw
➝
.
Side
duct
Upper
Exhaust
duct
4. Remove and retain outer case screw at rear
of the oven (right side)
5. Install the grommet and the electrical cord
of the microwave in the receiving hole pro-
vided in the rear intake duct, and position
this duct on rear of the oven (right side).
Fasten with outer case screw.
7. Position top intake duct on upper (right side)
of oven and fasten it together with rear in-
take duct by using 4 screws #8x1/4
8. Apply tape along all ducts flanges. Press tape
to secure properly.
Grommet
Screw
#8x1/4
➝
.
Note: The four (4) ducts have a plastic cover-
ing that must be removed prior to installing
these ducts onto the microwave section. These
ducts have sharp edges. Be careful when han-
dling.