Toshiba CGSV90CC3 - Manual (Page 20)

D4153660A 12
(8) Gamma correction ON(Gamma = 0.65) /OFF(Gamma = 1.0) switching
initial factory setting: ON
* When Raw output mode(8/10bit),
Gamma correction function is disabled (OFF fixed).
(9) Masking correction ON fixed
* When Raw output mode(8/10bit),
Masking correction function is disabled (OFF fixed).
(10) White balance OPWB / MWB switching (initial factory setting: MWB)
- OPWB (One Push White Balance)
Effective range 2500 K to 6500 K
Effective area Full screen
* When the random shutter is active, OPWB function is disabled.
* When Raw output mode (8/10bit), OPWB function is disabled.
- MWB (Manual White Balance)
Setting range 2500 K to 6500 K
Setting method R-gain and B-gain can be set independently.
* When Raw output mode (8/10bit), MWB setting is disabled.
(11) Setup-level 6.3 to 25 % (192step)
initial factory setting: 6.3% [Approximately 16digit/8bit]
* When Raw output mode (8/10bit), Setup-level setting is disabled.
(12) Power supply DC 12V +/-10% (ripple 100 mV(p-p) or less)
(13) Power consumption 3W Max (Maximum)
[Internal sync signal specification]
(1) Base clock frequency 36.0000 MHz +/- 100ppm
［ ［［ ［Trigger signal specification］］］］
(1) External trigger input
- Input level Low level: 0 to 0.5V
High level: 2.0 to 5.0V
- Polarity Positive / Negative bipolar
- Pulse width 2us (Minimum)
- Input impedance High impedance
(2) Software trigger Set via the Gigabit Ethernet interface
[Output signal specification]
(1) BUSY_OUT The period that input of the trigger signal is forbidden.
- Output level LVTTL
- Polarity Positive
(2) EXPOSE_OUT The period that this camera exposes.
- Output level LVTTL
- Polarity Positive