Parallel printer, Parallel printer -16 – Toshiba PSA20 User Manual
Page 152
User's Manual
8-16
O
PTIONAL
D
EVICES
4.
Select
640 by 480, High Color (16 bit), 60 Hertz
.
Figure 8-15 Resolution menu
Parallel printer
You can connect any standard Centronics-compatible parallel printer to your
computer. All you need is an IBM PC™ parallel printer cable. Your dealer can
supply one or you can purchase one at most computer stores.
The cable’s connectors are designed so that it is impossible for you to connect
them incorrectly. To connect a printer, follow these steps:
1.
Turn off the computer.
2.
Insert one end of the cable into the computer’s parallel port.
3.
Tighten the screws that fasten the cable connector to the computer’s parallel
port.
4.
Insert the other end of the cable into the printer’s parallel connector.
5.
Fasten the connector to the printer with the clips on the parallel port.
6.
Turn on the printer.
7. Turn on the computer.
8. Start the HW Setup program. Refer to Chapter 7,
9. Select the
Parallel/Printer
tab from the
TOSHIBA HW Setup
window.
10. Set the
Parallel Port Mode
and press
OK
.
11. Choose
Reboot
for the change to take effect.