Toshiba PSA20 - Manual (Page 73)

O
PERATING
B
ASICS
4-3
Disconnecting 3 1/2" diskette drive
When you have finished using the diskette drive, follow the procedures below to
disconnect it:
1. Wait for the indicator light to go out to make sure all diskette activity has
stopped.
CAUTION: If you disconnect the diskette drive or turn off the power
while the computer is accessing the drive you may lose data or damage
the diskette or the drive.
2. Click the Safety Remove Hardware icon on the Task Bar.
3. Click Diskette drive .
4. Pull the diskette drive connector out of the USB port.
Using optical media drives
The illustrations in this section might differ slightly from your drive, but, operation
is the same for all optical media drives. The full-size drive provides high-perfor-
mance execution of CD/DVD-ROM-based programs. You can run either 12 cm
(4.72") or 8 cm (3.15") CD/DVDs without an adaptor. An ATAPI interface controller
is used for CD/DVD-ROM operation. When the computer is accessing a CD/DVD,
an indicator on the drive glows.
NOTE: Use the WinDVD 4 application to view DVD-Video discs.
If you have a CD-RW/DVD-ROM drive, refer also to the Writing CDs on CD-RW/
DVD-ROM drive section for precautions on writing to CDs.
If you have a DVD-R/-RW drive, refer also to the Writing CD/DVDs on DVD-R/-RW
drive section for precautions on writing to CDs.
If you have a DVD Multi drive, refer also to the Writing CD/DVDs on DVD Multi
drive section for precautions on writing to CDs.
Using optical media drives