Teac Double Auto Reverse Cassette Deck W-890R - Manual (Page 17)

17
EN
GL
IS
H
Continuous recording
This function allows you to make uninterrupted recordings on both
sides of two tapes.
1 Load cassette tapes for recording into the TAPE I and
TAPE II compartments.
Side “A” facing you
2 Set the REV MODE switch to the p (CONT REC/PLAY)
position.
Set the DOLBY NR switch to the ON position if you want to.
3 Press the TAPE I deck’s RECORD ( K) key.
The deck enters the record-pause mode. J and will light
on the display. Now adjust the recording level and any other
settings, as required.
4 Check the recording direction.
If an indicator is lit which points in the direction opposite to
the one desired, change the direction by pressing the opposite
direction PLAY (
h or y) key.
NOTE
Be careful not to press the PLAY ( h or y) key whose arrow
points in the same direction as the indicator. Doing so will start
recording.
Recording is done in this order:
TAPE I Side “A”
x
Side “B”
x
TAPE II Side “A”
x
Side “B”
You can start recording from side “B” of TAPE I. But if you do so,
side “A” of this tape is not recorded: when recording reaches the
end of side “B”, the TAPE
II deck starts recording.
NOTE
The TAPE II deck always starts recording from side “A”.
5 Start recording.
Recording starts when you press the PAUSE key or the PLAY
(
h or y) key whose arrow points in the same direction as the
indicator on the TAPE I deck.
When recording is finished on the TAPE I deck, the TAPE II deck
automatically starts recording.
NOTE
The transition from TAPE I to TAPE II takes several seconds.
A To stop recording
Press the STOP ( H) key of the deck which is currently recording.