Installing/removing batteries, Installing/removing batteries -18 – Toshiba P200 Series User Manual

Page 139

Advertising
background image

User’s Manual

9-18

Optional Devices

Installing/Removing batteries

Be sure to install the dry batteries provided with this product using the

Remote Controller.
The procedures for installing and removing the bateries vary depending on

the type of the Remote Controller. Check the type and then install or

remove the bateries as instructed.

Store the battery for the remote control beyond the reach of children.
If a child swallows a battery, this might result in chocking. If it happens,

contact a doctor immediately.

Observe the following precautions when using the battery of the Remote

Controller.

Do not use batteries other than those specified.

Ensure that you insert the batteries with their polarities correctly

aligned (+ or -).

Do not recharge, heat, disassemble or shot the battery, or put it into a

fire or flame.

Do not use a battery whose ‘recommended expiration date’ has been

reached, or is completely discharged.

Do not use different type of battery or old and new batteries at the

same time.

Do not carry the battery together with metal necklaces, hairpins or

other metal accessories.

When storing or disposing of used batteries, make sure to put some

insulation tape on their terminal (+ and -) to avoid short-circuits.

If these precausions are not followed, heating, fluid leakage or explosion

may occur. This may cause bums or personal injury. If battery fluid gets on

your skin or clothes, wash immediately with clean water. If battery fluid

gets in your eyes, rinse your eyes with clean water immediately and see a

doctor. Do not touch the battery fluid on instruments or devices with bare

hands. Wipe off with a cloth or paper towel.

Advertising