Toshiba P200 Series User Manual
Page 152
User’s Manual
10-9
Troubleshooting
Sound system
Pointing device
If you are using a USB mouse, also refer to the
section in this chapter
and to your mouse documentation.
TouchPad
Problem
Procedure
No display
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display
priority and make sure it is not set for the internal
display.
Display error occurs
Check that the cable connecting the external
monitor to the computer is attached firmly.
If problems persist, contact your dealer.
Monitor goes into
panning mode
Check your monitor specification. It might not
support the selected resolution and refresh rate.
The resolution on the monitor might go into
panning mode when wide screen resolution is
selected. Refer to Appendix B,
.
Problem
Procedure
No sound is heard
Adjust the volume control dial.
Check the software volume settings.
If appropriate, make sure the headphone
connection is secure. Check Windows Device
Manager and ensure the sound function is
enabled and that settings for I/O address,
interrupt level and DMA are correct for your
software and do not conflict with other hardware
devices that you have connected to the
computer.
If problems persist, contact your dealer.
Problem
Procedure
On-screen pointer does
not respond to Pad
operation
The system might be busy. If the pointer is
shaped as an hourglass, wait for it to resume its
normal shape and try again to move it. You may
also press Fn + F9 to enable the TouchPad and
then try again to move it.