GIGABYTE GA-MA790XT-UD4P - Manual (Page 75)

Appendix - 75 -
C. Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step if you do not want to create
RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press <Ctrl-F> to enter FastBuild (tm) Utility" (Figure 2). Hit the <Ctrl>+<F> key to enter the
RAID BIOS setup utility.
Figure 2
RAID Option ROM Version 3.0.1540.47
(c) 2008 Advanced Micro Devices, Inc. All rights reserved.
No Array is defined..
Press <Ctrl-F> to enter FastBuild (tm) Utility...
Step 2:
Main Menu
This is the first option screen when you enter the BIOS RAID Setup utility. (Figure 3).
To view the disk drives assigned to arrays, press <1> to enter the View Drive Assignments window.
To create an array, press <2> to enter the Define LD window.
To delete an array, press <3> to enter the Delete LD window.
To view controller settings, press <4> to enter the Controller Configuration window.
Figure 3
View Drive Assignments...........................[ 1 ]
Define LD..................................................[ 2 ]
Delete LD.................................................. [ 3 ]
Controller Configuration............................ [ 4 ]
Press 1..4 to Select Option [ESC] Exit
FastBuild (tm) Utility (c) 2008 Advanced Micro Devices, Inc.
[ Main Menu ]
[ Keys Available ]