TacT Audio S2150 - Manual (Page 14)

CAUTION CAUTION
14 Tact Audio
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
1234567890123456789012345678901212345678901234567890123456789012123456
Biamping - continued
When two or more 2150 amplifiers are configured in a bi-/tri-amped setup, both the
signal and the RS232 TacT System Bus must be daisy chained between the amplifi-
ers.
The same signal flow is applicable for both horizontal and vertical bi-amping.
From RCS2.0S, RCS2.2X or
TCS mkII *Optional From source
AMP-1
AMP-2
AMP-3 - ONLY PRESENT IN TRI-AMPED SETUP
RS232
RS232
RS232
Digital signal
(coax/SPDIF)
Digital signal
(coax/SPDIF)
Digital signal
(coax/SPDIF)
M/S 2150 Connections
With its advanced DSP control, the M/S 2150 can enable digital crossovers
(high-and low-pass) making it is possible to configure the 2150 amplifiers to
virtually any system.
Examples of how a TacT active system can be configured:
1) Active two-way. The M2150 operates as master amp (control unit) and the
S2150 operates as slave amp. M2150 has a DSP-based high-pass filter and
drives the high-section of the 2-way loudspeaker. S2150 has a low-pass filter and
drives the bass-section.
2) Active three-way. The Tact RCS operates as master pre-amp and the three
S2150 operates as slave amps. The top S2150 has a DSP-controlled high-pass
filter and drives the tweeter section. The middle S2150 has a High- and low-pass
filter and drives the midrange section. The bottom S2150 has a low-pass filter
and drives the bass section.
M2150 & S2150
Configurations