Toshiba RAS-18LAH-A - Manual (Page 23)

UNIT OPERATION
EMERGENCY AND TEST OPERATION
Test Operation
This operation is used for checking after unit installation.
• Press the TEST button.
• Press the TEST button once more after checking to activate remote control. If there is any input
signal ( remote control signal or EMERGENCY button pressed ) during test operation, the TEST mode will
change to the input signal mode.
• The setting conditions of the test operation are as follows:
- Operation mode : COOL
- Fan speed : HIGH
- Timer mode : Disable
- Discharge air direction : SWING
Emergency Operation
When the remote control is lost, damaged or the battery is discharged, the EMERGENCY button can be used
to run the unit.
• Press the EMERGENCY button at the off mode condition.
- The unit operates automatically according to the room temperature by selecting either the cooling or
the heating operation.
• If you want to stop the emergency operation, push the EMERGENCY button again or operate the remote control.
• The setting conditions of emergency operation are as follows:
- Operation mode : AUTO
- Preset temperature : 25
°
c
- Fan speed : AUTO
- Timer mode : Disable
- Discharge air direction : Set automatically according to operation mode. ( Refer to p. 20 )
EMERGENCY
TEST
OWNER , S MANUAL - 21