Perreaux SM6 MKII - Manual (Page 12)

12
Note: The position of the Balanced Input switch has no bearing on the
balanced output, it only selects which input to use for input A. Set the
Balanced Input switch to ON only when using the balanc ed input....
Refer to Chapter 13 “Specifications”, for detail on input sensitivity and
impedance.
Unbalanced Source Inputs
Accepts a standard single-ended input (RCA) from source components with
single-ended analogue outputs. These high quality gold plated sockets are
highly conductive, corrosion resistant, and provide less potential for corrosion
induced distortion.
Caution! Input D fixes the output to 0dB, as it is a home theatre bypass. Please
ensure the level is suitably attenuated by the upstream processor or
receiver before s electing this input.
Refer to Chapter 13 “Specifications”, for detail on input sensitivity and
impedance.
Tape 1 Line Outputs
This single-ended (RCA) output will provide a line level audio signal, suitable
for recording, from the selected source input. This output is disconnected when
source input E is selected; to prevent any potentially damaging feedback loops.
Tape 2 Line Outputs
This single-ended (RCA) output will provide a line level audio signal, suitable
for recording, from the selected source input. This output is disconnected when
source input F is selected; to prevent any potentially damaging feedback loops.
Preamp Output 1
This single-ended (RCA) output is commonly referred to as “Preamp Out”. It
will provide the audio signal required to drive virtually any amplifier to full
power.
Preamp Output 2
This single-ended (RCA) output is wired in parallel with M ain Output 1 and is
useful for supplying signal to another amplifier if bi-amping.
Balanced Outputs
This balanced (XLR) preamplifier output provides the signal required to drive
virtually any power amplifier equipped with a balanced input. Connection
should be made with high quality cables fitted with XLR connectors.
Note: The position of the Balanced Input switch has no bearing on the
balanced output; it only selects which input to use for source input A.