Toshiba RBC-AMS41E - Manual (Page 7)

GRUPAd.o.o.
6
Correct operating procedures
The functions will differ depending on the model and
system.
• Follow the steps below before using the remote
control system for the very first time or when changing
any of the settings.
• After the steps have been followed, operation will
commence using the settings established simply by
pushing the
button (32).
Preparations
Turn on the ground fault interrupter.
• When the power is turned on, a dividing line appears
on the remote controller display.
* For about a minute after the power has been turned
on, on the LCD screen blinks, and there
will be no response to the keys of the remote
controller even when they are pushed.
Notes
• Do not turn off the ground fault interrupter during the
operating season of the remote control system.
• After the remote control system has been shut down
for a prolonged period, turn on the ground fault
interrupter back on at least 12 hours before its
operation is to be started.
Starting operation
1 Push the button (32) to start operation.
• The ON lamp lights, and the operation details are
displayed on the LCD screen.
2 Push the button (34), and select the mode of
operation.
• Each time this button is pushed, the operation
mode display changes in the sequence shown
below.
• Stop pushing the button when the symbol
corresponding to the desired mode of operation
lights.
3 Push the button (32) to shut down
operation.
• The ON lamp goes off, and the operation details
are cleared from the LCD screen. (The frame lines
remain displayed.)
• Before operation shuts down, the self-cleaning
operation is commenced if the air conditioner was
run in the Auto (during cooling), cooling or dry
mode for 10 or more minutes.
* For details on the self-cleaning operation, refer to
the “Self-cleaning operations” section.
Changing the air speed
1 Push the button (33), and select the desired
air speed.
• Each time the button is pushed, the air speed
display changes in the sequence shown below.
• Stop pushing the button when the symbol
corresponding to the desired air speed lights.
* If, during heating, the rooms do not heat up
quickly at the low air speed setting, change the
setting to high or medium.
* The auto air speed cannot be selected during fan
operations.
Changing the temperature
1 Push the TEMP and buttons (49), and
select the desired temperature setting.
• When the button (49) is pushed, the
temperature on the numeric display goes down;
conversely, when the
button (49) is pushed, the
temperature displayed goes up.
• The temperature cannot be set during fan
operations.
Procedure for normal operation
Auto
Fan Dry Cooling
Heating
Auto air speed
Low air speed Medium air speed
High air speed
MB FRIGO Grupa d.o.o., Bani 81, 10010 Zagreb, www.toshiba.hr, e-mail: [email protected]