Toro GREENSMASTER 3100 - Manual (Page 78)

Lift Cylinder Removal and Installation
No. 1 (Center) Lift Cylinder (Fig. 32)
Figure 32
1. Put drain pan under machine.
2. Remove hydraulic lines.
3. Remove capscrew (Item 25) and locknut (Item 29)
securing pin (Item 26) in barrel end of cylinder (Item 10).
4. Remove pin (Item 26) securing barrel end of cylinder
to the frame.
5. Remove cylinder (Item 10) by lowering barrel end and
sliding shaft/clevis end off of the lift arm (Item 21).
6. Reverse steps 2 - 5 to install the cylinder. Coat
cylinder pivot on lift arm (Item 21) with Never-Seez or
grease to achieve free pivot action of lift arm in cylinder
clevis before reinstalling.
IMPORTANT: When disassembling hydraulic lines
make sure hydraulic plugs are placed in the open
end of the hydraulic line to prevent foreign debris
from contaminating hydraulic oil. It is also a good
idea to tag the hydraulic lines when disassembling
so they can be properly reassembled. Keep all hy-
draulic lines clean and free from foreign debris.
During replacement of lift cylinder, avoid overtight-
ening fittings. Check hydraulic lines for cracks or
breaks. If a hydraulic leak should appear after re-
placement of lift cylinder, replace the fitting or line
that is leaking. Check hydraulic reservoir for level
of hydraulic fluid after replacement of lift cylinder.
Repairs Page 4 - 50 Greensmaster
®
3100