Installation, Selecting a location, Remove desktop/wall adapter – Ultratec CRYSTALTONE 305-009901 User Manual

Page 6: Setting pulse or tone dialing, Setting up the crystaltone

Advertising
background image

To set up the C r y s t a l To n e , all you do is
connect the telephone line! You can also
choose to mount the phone on the wall.

CrystalTone includes the following parts:

CrystalTone amplified phone

Handset with coiled cord

7-foot telephone line cord

6-inch telephone line cord (for use when
mounting on wall)

Desktop/wall adapter

CAUTION! Do not plug the CrystalTone

into any telephone line other than a standard,
analog telephone line. Connection to a digital
system may damage the CrystalTone or the
telephone system and will void your warranty.

1. SELECTING A LOCATION

The CrystalTone requires a standard (analog)

telephone line with either pulse or tone (also

called t o u c h t o n e) dialing. To use the
C r y s t a l To n e with a digital system, some
modifications to the telephone line are
required.

Set up the CrystalTone in a place where:

There is a phone jack nearby.

The surface it is set on, or mounted to, is
stable and secure.

The area is protected from excessive heat or
humidity.

2. REMOVE DESKTOP/WALL ADAPTER

If it is connected, remove the desk-top/wall
adapter. (This will be
replaced after setup
is complete.)

3. SETTING PULSE OR TONE DIALING

The CrystalTone is preset to
use t o n e dialing because
this is used by most

telephone lines. If your line
uses pulse dialing, move the
switch located on the bottom of the

CrystalTone to the “Pulse” setting.

4. SETTING UP THE CRYSTALTONE

For Desktop Use

1. Connect the uncoiled end of the handset

cord to the jack on bottom of the
CrystalTone . Plug the other end of the cord
into the handset.

2. If the desktop/wall adapter is not removed,

remove it now (see step 2).

3. Plug the telephone line cord into the

telephone line jack on the bottom of the
C r y s t a l To n e and the other end into the
wall phone jack.

4. Replace the desktop/wall adapter so that

the larger side is along the top edge of the
CrystalTone .

5. Set the C r y s t a l -

Tone on a sturdy
surface such as a
desk, table or
counter.

INSTALLATION

4

I N S TA L L AT I O N

Advertising