Ultratec CRYSTALTONE 305-009901 - Manual (Page 7)

Mounting on a Wall
1. Flip the handset
hook over so that
the hook points
up and will hold
the handset when
you hang it up.
2. Connect the uncoiled end of the handset
cord to the jack on bottom of the
CrystalTone . Plug the other end of the cord
into the handset.
3. Plug the 6-inch telephone line cord into
the CrystalTone .
4. Replace the desktop/wall adapter so the
larger side is down. This aligns the
CrystalTone so that it is flat when mounted
on the wall.
5. Plug the telephone cord into the wall jack.
Then, line up the
holes in the wall-
mount bracket
with the mount-
ing studs on the
wall plate. Hook
the bracket on
the studs then pull down.
5. CONNECTING AN EXTERNAL
SIGNALER
To use a separate, optional signal light, plug
the signaler into an unused extension
telephone wall jack.
If you have only one
jack that is being
used
by the
C r y s t a l To n e , you
can use a “Y- J a c k ”
(also
called a
“duplex jack”).
Plug both the CrystalTone and the signaler
into the Y-jack and plug the Y-jack into the
wall jack. You can purchase a Y-jack at any
store that sells telephones.
6. CONNECTING A HEADSET RECEIVER
The CrystalTone provides an audio jack for
direct audio connections with some assistive
listening technology. A headset with a 3.5 mm
jack may also be used. The headset may be
either mono or stereo. The jack, which is
labeled
with the headset symbol
( ), is located on the right side of the
CrystalTone .
I N S TA L L ATION ■ 5
CALLING & ANSWERING
The C r y s t a l To n e works just like any
telephone.
PLACING A CALL
1. Lift the Handset.
2. Listen for the dial tone.
3. Dial the number of the person you are
calling. When the person answers the
phone, begin your conversation.
4. During a conversation, you may want to
adjust the volume and quality of the sound
coming through the handset (see
“Adjusting the Sound ” on the next page).
ANSWERING A CALL
1. When you receive a call, the CrystalTone
rings and the Ring Indicator flashes slowly
along with the rings.
NOTE: If the ring volume is not loud
enough to alert you to a call, you can
increase the ring volume (see “Adjusting
the Sound” on the next page).
2. Pick up the handset to answer the call and
begin your conversation.