U-Line ICE-MAKER - Manual (Page 31)

12. Adjust door to assure proper seal. Tighten upper hinge screws
securely.
13. Replace three plastic plugs removed in step 8 into holes on top of
unit. Replace screws in holes in bottom of unit, opposite side.
14. Reinspect door seal and alignment. Adjust if needed.
15. Reinstall grille (one screw).
NOTE
On Combo Model 75A (built-in installations only), changing
the door mounting to the left side may interfere with ice
bucket removal. See BUILT-IN INSTALLATION section for
clearance requirements. The 75 BEV is not reversible. Any
reference to reversing the door does not apply.
To reverse the door mounting on Models Combo 75A and 75R
(except Stainless Steel models) perform the following:
1. Remove grille (one screw) (Figure 22).
2. Remove top hinge from cabinet (four screws) (Figure 23). Hold
door to keep it from falling.
3. Lift the door off the bottom hinge.
4. Remove four plastic plugs in hinge holes, top of cabinet, opposite
side (Figure 29). Be careful not to scratch cabinet.
5. Remove pivot screw from top
hinge, invert screw and rein-
stall pivot screw in top hinge
(Figure 28). Do not install
hinge on cabinet at this time.
6. Remove bottom hinge from
cabinet (four screws) and
screws on opposite side of
cabinet (Figure 31).
7. Remove pivot screw from bot-
tom hinge, invert screw and
reinstall pivot screw in hinge
(Figure 28).
UL128
29
Figure 31
30035 User Manual Body.qxd 1/5/05 8:08 AM Page 29