U-Line ICE-MAKER - Manual (Page 37)

35
Allow unit temperature to stabilize for 24 hours before use.
4. Open the water supply valve in the main water source. As soon as
the ice maker mold reaches the proper temperature, the ice
maker mechanism will fill the mold with water. The first cubes may
be small because of air in the water line. Subsequent cubes will be
of standard size. Approximate time for the first cycle is 45 min-
utes. Allow two hours for Frostfree models.
TEMPERATURE CONTROL
Models BI-95 and BI-98: Use a flat tip screwdriver to turn adjusting
screw, located behind front grille, clockwise for colder (slower ice
production) or counterclockwise for warmer (faster ice production)
(Figure 37).
Series 15, 29 and 75: Adjust control setting by turning the numbered
dial (Figure 38).
NOTE
Model SP18 temperature control has been preset at the
factory for optimum ice production. Do not attempt to
make adjustments.
UL504
1
2
3
4 5
6
7
CONTROL
UL012A
C
O L D E
R
Figure 37 Figure 38
30035 User Manual Body.qxd 1/5/05 8:08 AM Page 35