United States Stove Company VF30IN - Manual (Page 17)

17
LOGS AND LOG STOP ASSEMBLY
LOG POSITIONING
This unit is supplied with a set of four ceramic fiber logs. Do not handle these logs with your bare hands! Always
wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap
and water to remove any traces of fibers.
PROPER INSTALLATION SEQUENCE:
1. Install the rear log (#2) on the rear set of locators. Visually check to verify the log is securely placed on the
locators.
2. Install the front log (#1) on the front locators. Visually check to verify the log is securely placed on the locators.
3. Install the left and right cross twigs as illustrated, on the locator pins provided in the front and rear logs. Holes
provided in the bottom of the cross twigs should allow them to seat completely over these pins.
#1
#2
WARNING: Failure to position the
parts in accordance with these
diagrams or failure to use only parts
specifically approved with this heater
may result in property damage or
personal injury.
FIGURE 8. Log Set Assembly
WARNING
The positioning of the logs is critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly
situated in the appliance. Never add additional logs or embellishments such as
pine cones, vermiculite or rock wool to the heater.
Cross section of firebox
LOG STOP POSITIONING
This unit is also supplied with a decorative Log Stop. To install the Log
Stop simply place it in front of the Front Log, resting on the Front Brace as
shown in the illustration to the right.