Uniden BC45XLT - Manual (Page 14)

10
Before the BC45XLT can receive radio broadcasts, you must
program a frequency into at least one channel.
Before scanning, repeat this procedure for each channel you
program.
1. Select frequencies from your
starter guide.
2. Press .
3. Select a channel.
a. Enter the channel number.
b. Then press
.
– OR –
Press ▲ , ▼ , or
repeatedly until the channel
number appears in the display.
4. Enter the frequency.
a. Enter the frequency
number.
b. Then press .
Note: To clear a mistake while
entering the frequency,
press twice,
and
start over.
If the frequency entered is outside the Frequency Range of the
scanner, a distinctive beep sounds. (See the Table on page 3
or the Band List on the back of the scanner).
Press and go back to Step 4.
Programming
a b
a
b
BC45XLT 11/2/00 9:04 Page 10