Unitech Hand Held Scanner - Manual (Page 14)

Page 13
Chapter 5 Wand Emulation
5.1 Installation
Figure 4 shows how a wand emulation scanner is installed to a data
collection terminal. User needs to pay attention to the scanner pinout
that should be the same as specified by the terminal.
Figure 4. Installed as a Wand Emulation Scanner
SCANNER
5.2 Understanding the Operating Parameters
Code 39 Output:
When device number “07” is selected, the scanner is set as wand
emulation with Code 39 output. In this configuration, the scanner
always outputs data with Code 39 symbology no matter what
symbology of the label it scans. You may scan the following label if
this setting matched your application.
Code39 Wand
Emulation
Native Output:
When device number “26” is selected, the scanner is set to wand
emulation with native output. That means the scanner outputs data
with both the same contents and symbology as the label represents.