Powering on your 1800 series pos bundle system – Ultimate Technology 1800 User Manual
Page 11
13. Plug the PC power cord into the receptacle on the rear of the PC and then into the wall outlet or
optional Power Conditioner.
Figure 11:
Rear View of PC, Power cord connection
Powering On Your 1800 Series POS Bundle System
1. Remove the plastic protective sheets from the LCD Monitor and the optional rear customer display.
2. Turn on the ATX PC power by depressing the on/off switch located on the lower front right-hand side of
the unit.
3. To activate the printer, turn on the printer rocker switch located on the front of the printer.
You have completed the installation of UTC RETAIL’s 1800 Series Bundled Point of Sale System. If you
experience problems with any of the components of the 1800 Series Bundled POS System, see the
“Troubleshooting Procedures” section below.
© 2008 UTC RETAIL. All rights reserved.
11692014 Rev C
Page 11 of 12