Ultimate Technology 1800 User Manual
Page 7
7. Connect the USB connector end of the Barcode Scanner cable to a USB port on the back of the
PC. Connect the other end into the jack on the barcode scanner handle.
Figure 5:
Rear View of PC, Scanner connection
8. Connect the optional MSR (Magnetic Stripe Reader) assembly to the 1800 Series unit as follows:
Figure 6:
Back View of 1800 Unit and MSR Assembly
1. Connect the USB cable
Insert the USB connector into the USB port at
the side of the main unit.
2. Position the MSR
Align the MSR unit with the guide rails on the
main unit and slide it into position, making
sure the entire USB cable is covered by the
MSR housing.
3. Insert and tighten screws
Insert the two screws provided with the MSR
unit, and tighten to secure the MSR housing
to the main unit.
Main Unit
USB Port
To MSR Unit
MSR Unit
Insert screws
USB
© 2008 UTC RETAIL. All rights reserved.
11692014 Rev C
Page 7 of 12