UTStarcom CDM-105 - Manual (Page 20)

Section 2A: Your Sprint PCS Phone – The Basics 25
Always use a Sprint-approved desktop charger, travel
charger, or vehicle power adapter to charge your battery.
Warning: Using the wrong battery charger could cause damage to your
phone and void the warranty.
Using the Charger
To use the travel charger provided with your phone:
ᮣ Connect one end of the charger into the phone's
charger jack and plug the other end into a standard
100~240V AC wall outlet. You can monitor the
battery status by checking the battery level indicator.
It takes approximately 3 hours to fully recharge a
completely rundown battery. With the Sprint-approved
LiIon battery, you can recharge the battery before it
becomes completely run down.
Phone Basics
24 Section 2A: Your Sprint PCS Phone – The Basics
2. Place the battery onto the phone, bottom first so the
tabs go into the bottom of the phone and the metal
connectors align. Then push the battery down until it
locks into place.
3. Place the battery cover over the battery and slide into
place.
Note: If the battery is not correctly placed in the compartment, the phone
will not turn on and/or the battery may detach during use.
Removing the Battery
To remove your battery:
ᮣ Pull down the release latch, lift up the battery cover
and remove the battery from the phone.
Charging the Battery
Your Sprint PCS Phone’s LiIon battery is rechargeable and
should be charged as soon as possible so you can begin
using your phone.
Keeping track of your battery’s charge is important. If your
battery level becomes too low, your phone automatically
turns off and you will lose all the information you were just
working on. For a quick check of your phone’s battery level,
glance at the battery charge indicator located in the upper-
right corner of your phone’s display screen. If the battery
charge is getting too low, the battery icon
blinks and
the phone sounds a warning tone.