UNICOM Electric Unicom Velocity 10/100/1000Base-T 1000Base-SX/LX Gigabit Ethernet Converter GEP-5400TF-C - Manual (Page 5)

Installing Converters into Chassis
Follow the steps below to install modular conver ters into the 10 space
Conver ter Chassis (pn: FEP-593110).
A. Remove the blank bracket from the chassis by rotating screw
counterclockwise. Put the blank bracket aside.
B. Open the rack mount bracket kit. The kit contains two rack mount
brackets and four screws.
C. Use a screwdriver to attach the rack mount ears to both sides of
the modular conver ter.
D. Install the modular conver ter by inser ting it into the chassis
guides and sliding it in until it stops. Press it firmly to seat the
chassis power plug into the modular conver ter receptacle.
E. Gently push the thumbscrews in and turn clockwise to tighten.
Do not over tighten.
7 4
Hardware Description
The Front Panel
The Front Panel of the 10/100/1000T to 1000SX/LX conver ters
consists of one RJ-45 Por t ( Auto MDI/MDIX ) one fiber 1000Base-
SX/LX Por t and 6 LED Indicators (SPD, LK/ACT, FDX, Fiber LK/ACT,
FDX/COL and PWR ).
Ports
• Copper Port: RJ-45 Por t (Auto MDI/MDIX), the Ethernet RJ-45 will
features Auto-Sensing for 10/100/1000Base-T connections and
Auto MDI/MDIX which is basically an auto crossover feature. This
means you can connect to another Switch or workstation without
changing to a crossover cable.
• Fiber Port: This por t is for the 1000Base-SX/LX connection and is
available in the SC format in Multi- and Single mode.This fiber por t
does not suppor t auto-negotiation.
The Rear Panel
The rear panel contains a power socket. This power socket accepts
DC9V voltage and minimum 0.7A supplied current.
Multi-Mode Auto MDI/MDIX
10/100/1000T 100Base-SX
LK/ACT
FDX/COL
SPD PWR
1 2 3
ON
Single Mode Auto MDI/MDIX
10/100/1000T 1000Base-LX
LK/ACT
FDX/COL
SPD PWR
1 2 3
ON
GEP-5300TF-C 550m
GEP-5400TF-C 10km
DC IN
Auto MDI/MDIX
10/100/1000T
100Base-SX
SPD