UNICOM Electric DynaGST/1602G - Manual (Page 11)

8
3. Installation
Set the Switch on a sufficiently large flat space with a power outlet nearby.
The surface should be clean, smooth, level, and sturdy. Ensure there is
enough clearance around the Switch to allow air circulation and the
attachment of the power cord and cables.
Attaching Rubber Feet
Make sure mounting surface on the bottom of the Switch is grease and
dust free.
Remove adhesive backing from your Rubber Feet.
Apply the Rubber Feet to each corner on the bottom of the Switch.
These footpads protect the Switch from shock and vibration.
Power On
Connect the power adapter cable to the power socket on the rear panel of
the Switch. The other end of the power cord connects to the power outlet.
Check the power indicator on the front panel to make sure if power is
properly supplied.