Universal Electronics URC-3021 - Manual (Page 11)

11
PROGRAMMING A MASTER POWER MACRO (cont’d)
Clearing The Master Power Macro
1. Press and hold SET until the LED (red light) blinks twice,
then release SET .
2. Enter 9 - 9 - 5 . The LED will blink twice. Then press POWER
once.
3. Press and hold SET until the LED blinks twice, then release
SET . The Master Power Macro is now cleared.
RE-ASSIGNING DEVICE KEYS
The One For All 3 Device Universal Remote Control can be set to control a
DVD player and a VCR (or a PVR) or a second DVD player by re-assigning
the unused
CBL/SAT key as follows:
1. On the remote control, press and hold SET until the LED
(red light) blinks twice, then release SET .
2. Enter 9 - 9 - 2 . The LED will blink twice.
3. Press DVD/VCR once.
4. Press CBL/SAT once.The LED will blink twice.The CBL/SAT key
is now ready to be set up to control your VCR (or PVR) or
second DVD player.See
Programming Device Control on page
8.
NOTE: Only one device can be assigned to an unused device key at a time.
USING CHANNEL SCAN
In the CBL/SAT or TV mode, use the FAV key to start a 3-second scan of all
channels. Or, if programmed, use the FAV key to scan only your favorite
channels to view a desired channel (see Programming Favorite Channel Scan
on next page. )
1. Press CBL/SAT or TV once.
2. Press FAV once.
• If Favorite Channel Scan has been set up, scanning of favorite
channels will start with up to 100 channel changes or until
stopped by pressing any key.
• If Favorite Channel Scan has not been set up, scanning
will start with the current channel, and continue up to
100 channel changes or until stopped by pressing any key.
3. To stop scanning channels at any time, press any key once.
CTGAE3P 3021 manual booklet 5/24/04 12:46 PM Page 11