Universal Electronics URC-3021 - Manual (Page 13)

13
CHANGING VOLUME LOCK (cont’d)
Locking Volume Control To One Mode
(Global Volume Lock)
2. Enter 9 - 9 - 3 and then press any mode key once (e.g., TV ).
The LED will blink twice.
3. Now, when you press VOL
▲
, VOL
▼
, or MUTE , the volume of
the selected device (e.g., TV ) will be controlled, regardless
of the mode you have selected.
Unlocking Volume Control For A Single Device (Individual Volume
Unlock)
1. After performing Global Volume Lock (above), press a desired
mode key where you want volume to be unlocked (e.g.,
DVD/VCR ) and controlled within its own mode.
2. Press and and hold SET until the LED (red light) blinks twice,
then release SET .
3. Enter 9 - 9 - 3 and then press VOL
▼
once. The LED will
blink four times.
4. If desired, repeat steps 1 through 3 (of this section) for
each device that you want volume to be unlocked.
5. After selecting a device that has volume unlocked (e.g.,
DVD/VCR ), pressing VOL
▲
, VOL
▼
, or MUTE will control the
device’s volume only in its own mode.
Unlocking All Volume Control (Restoring Default Setting)
NOTE: Performing these instructions will restore independent volume control for all pro-
grammed devices (e.g., TV volume control in TV mode, VCR volume in DVD/VCR mode,
etc.).
1. On the remote control, press and hold SET until the LED (red
light) blinks twice, then release SET .
2. Enter 9 - 9 - 3 and then press VOL
▲
once. The LED will
blink four times.
3. Volume will again be independently controlled according
to its default states for all programmed devices.
CTGAE3P 3021 manual booklet 5/24/04 12:46 PM Page 13