Programming favorite channel scan, Changing volume lock – Universal Electronics URC-3021 User Manual

Page 12

Advertising
background image

12

PROGRAMMING FAVORITE CHANNEL SCAN

In the

CBL/SAT

or

TV

mode, you can store a list of up to 10 favorite channels,

in any order, that will be immediately scanned when

FAV

is pressed (see

Using Channel Scan

on the previous page).

NOTE: Favorite channels can only be programmed for one mode. After programming, if FAV
is pressed while in another mode, the remote control will start scanning all channels instead
(if applicable to the selected device).

1.

On the remote control, press

CBL/SAT

or

TV

once.

2.

Press and hold

SET

until the

LED

(red light) blinks twice,

then release

SET

.

3.

Enter

9

-

9

-

6

. The

LED

will blink twice.

4.

Use the keypad to enter a favorite channel number (e.g.,

031

). Then press

SET

once.

NOTE: If the original remote control required pressing an Enter key
to change the channel, also press the ENTER key after the channel
number (e.g., 0 - 3 - 1 - ENTER). On some satellite receivers and cable
boxes, you may need to press the SELECT (OK) key instead of ENTER.

5.

If desired, repeat step 4 for each channel to be stored, up
to a total of 10 channels.

NOTE: If you try entering more than 10 channels, the remote control
will automatically exit programming. To change your favorite chan-
nel list at this point, you will first need to delete the existing list by
performing the steps in “Clearing Custom Programming” on page 14.
Then, perform the instructions in this section once again.

6.

To exit programming with less than 10 favorite channels
stored, press and hold

SET

until the

LED

blinks twice.

Otherwise, the remote control will automatically exit the
program after 10 channels have been stored.

CHANGING VOLUME LOCK

The One For All 3 Device Universal Remote Control is set at the factory for
independent volume control of each selected device. However, you may
change the Volume Lock setting to

Global Volume Lock

so that a device’s vol-

ume will be locked to one mode (e.g., to control TV volume in all other
modes).After that, if desired, you can perform

Individual Volume Unlock

on

a selected device to set its volume control for independent operation.

Locking Volume Control To One Mode
(Global Volume Lock)

1.

Press and hold

SET

until the

LED

(red light) blinks twice,

then release

SET

.

continued on next page...

CTGAE3P 3021 manual booklet 5/24/04 12:46 PM Page 12

Advertising