Uniden 200 - Manual (Page 10)

E-6
Getting Started
Attaching the Antenna
1. Place antenna over antenna stub.
2. Thread antenna clockwise until fully seated
against mounting base. Hand tighten only.
NOTE
Be sure the antenna is firmly seated.
Set Battery Type
Your radio comes set to
Ni-MH
and with 6 Ni-MH batteries installed.
CAUTION
• Always set the battery switch to Alk. before installing
alkaline batteries.
• Do not recharge alkaline batteries. Doing so can create a
safety hazard or damage the radio.
• Always completely fasten screw for a water tight seal.
1. Unfasten battery case cover screw.
2. Lift cover and rotate up.
3. Remove 6 AAA Ni-MH batteries.
4. Slide the switch to
ALK.
(or
Ni-MH
if
replacing with Ni-MH batteries).
Install Batteries
1. Unscrew the battery case cover screw.
2. Lift up cover and rotate up.
3. Set the battery type (see above).
4. Install 6 AAA Ni-MH or 6 AAA alkaline
(not included) batteries. Be sure to match
the polarity (+ and -) as indicated on the
battery compartment.
5. Close battery case cover and fasten screw.
Alk. Ni-MH
Battery
Switch
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA