Univex Dual Mono Pre-Main Amplifier AM-77 - Manual (Page 47)

47
i. Power OFF via the ‘POWER’ (R12) switch at the rear of the AM-77.
ii. Connect the desired separate pre-amplifier to the AM-77 via the Balanced or RCA female connector
of Input 1 (R6).
iii. Using a small flat blade screwdriver, move the ‘MODE’ switch (R5) to the centre to select ‘L R’.
iv. Using a small flat blade screwdriver, move the ‘INT/POWER AMP’ switch (R4) to the left to select
‘POWER AMP’.
v. Power the AM-77 back on via the ‘POWER’ switch (R12).