Univex Dual Mono Pre-Main Amplifier AM-77 - Manual (Page 51)

51
Note: This function requires at least 2 x AM-77 synchronised pre-main amplifiers.
i. Power OFF via the ‘POWER’ (R12) switch at the rear of both AM-77s.
ii. Using a small flat blade screwdriver, move the ‘MODE’ switch (R5) to the right to select ‘MM’.
iii. Using a small flat blade screwdriver, move the ‘INT/POWER AMP’ switch (R4) to the left to select
‘POWER AMP’.
iv. Repeat this process for the other AM-77.
v. Power ON both AM-77s via the respective ‘POWER’ switch (R12).